SpeedFactory Racing Honda/Acura Titanium K-Series Intake
The use of factory intake manifold bolts and studs, especially with the use of an aftermarket intake manifold and/or thermal gasket, can result in stripped or broken bolts and inadequate clamping force, resulting in leaks. This stud kit looks great and will allow you to properly clamp the intake manifold to the cylinder head without experiencing sealing problems, stud/nut failure, or ugly and troublesome rust and corrosion. Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs.
SpeedFactory Titanium Stud Kits are made of high quality Ti 6Al-4V and incorporate a hex key tip that allows them to be easily installed using an Allen wrench. Titanium 10mm 12-point nuts and washers are included.
Each stud/washer/nut assembly weighs only 12g!
This kit incluces the following:
(8) M8 x 1.25mm x 45mm titanium studs
(8) 12-point M8x1.25mm titanium nuts
(8) M8 titanium washers
Available in standard or burnt titanium finish.
If you are not sure if these studs are compatible with your engine, please email support@speedfactoryracing.net or call us at (253)566-4331 for assistance.
